Analysis on the use and maintenance of film coating machine

The film coating machine is a device for coating sugars and films on the core of Chinese and Western medicine tablets It is mainly composed of main engine (sugar coating machine), controllable room temperature hot air system, automatic spray system for supplying liquid and gas            Installation and use of film coating machine: connect the power supply, pay attention to that the phase line and zero line cannot be connected wrongly; connect the air source with the air pipe connector at the lower side of the machine body through the Φ 8pu pipe; add coating liquid to the liquid cylinder; start the power switch, and then connect the power supply; adjust the speed of the main machine according to the instructions for the use of the main machine governor; turn on the air inlet regulating switch, and the air inlet fan starts to work; adjust the temperature controller, and set the temperature Adjust it to the temperature value you need If the actual temperature is lower than the setting value, the heater will be powered on and the heater will start to heat Turn on the spray gun switch and the spray gun will start to work After the above functions are adjusted properly, the air compressor can be turned on The air pressure is about 4-6kg / cm3           Use and maintenance of the film coating machine: place the main machine stably, move the spray supply bracket to the right side of the main machine, place the spray gun in the main machine coating pot, and adjust it to a reasonable position; connect the power supply, turn on the speed regulating switch of the main machine, and adjust the rotating speed and direction of the main machine; connect the gas and liquid pipes to add liquid to the liquid cup, turn on the gas and liquid switches, and adjust the spray amplitude and direction of the spray gun and liquid; move the blower port Adjust the heating temperature and direction according to the pot mouth; stop the machine for loading and work according to the coating process; clean the machinery and pipeline after use.