Application and common faults of semi-automatic capsule filling machine

The semi-automatic capsule filling machine is suitable for the assembly of 00 × 4 × capsule cap and body and the filling of medicine powder It is suitable for small and medium-sized pharmaceutical factories, health care products factories, hospitals, veterinary medicine factories, research institutes, laboratories, pesticide factories and small and medium-sized batch production of clinics and pharmacies with more patients Use of semi-automatic capsule filling machine: 1 Press the green button in the "power switch" to turn on the power 2 Slowly adjust the "vibration strength adjustment knob" and turn it clockwise At this time, the finishing disk, which is connected with the "vibration bracket", starts to vibrate Touch the finishing disk with your hand and adjust the vibration intensity according to your feeling 3 Put the powder filled capsule shell into the "powder filled capsule shell finishing plate", about 300 capsules each time Put the capsule cap into the "capsule cap finishing plate", about 300 capsules each time The finishing plate is made of plexiglass plate, on which there are many circular holes with big upper and small lower funnel shape, the diameter of which corresponds to the diameter of capsule number 4 In about 30 seconds, the powder filled capsule shell and capsule cap fall into the round hole with the opening facing up 5 Horizontal hand-held powder capsule shell connecting plate (shown at the end of the figure, it has been prepared randomly, and there is a round hole in the connecting plate) Push the bottom of the finishing plate slightly, and the powder capsule shell in the finishing plate will fall into the round hole of the connecting plate, and then take out the connecting plate In the same way, take out the capsule cap with the capsule cap connecting plate 6 Prepare a powder square plate with a bottom area of 500 × 500mm2 and a height of about 10 mm on four sides in advance, which is filled with powder, and place the connecting plate of powder filled capsule shell in the powder square plate 7 Use the matching capsule cap cover suit plate, put it on the capsule cap cover joint plate, with alignment holes, easy to place Turn over the capsule cap connecting plate, make the opening of the capsule face down, and cover it on the powder loaded capsule shell connecting plate, which also has a contraposition hole, so it is easy to cover 8 Put the sheathed capsule plate into the cavity under the "capsule cap forming plate", pull down the "pressure bar" with your hand and put it in place, do not need to be careful of excessive force, because there is a positioning mechanism to control the pressure height Take out the capsule plate and pour out the capsule Common faults of semi-automatic capsule filling machine: 1 The vibration is not ideal and the voltage is adjusted 2 The reed screw is loose and tightened 3 The capsule shell is arranged in the working platform plate, with the mouth higher or lower Adjust the height of the dislocation plate and the guide rail 4 The capsule shell has too many inverted heads (more than 3%), and the vibrator is not adjusted properly Because the proper voltage is adjusted or the capsule shell size is not up to the specification, the qualified capsule shell is selected 5 The capsule shell can not fall when it is stuck on the platen Replace the capsule shell or adjust the position of the dislocation plate and platen hole 6 The mold cannot be reset in the track, and the compression spring at the back end of the track is stuck or the capsule variant is stuck Reinstall the spring or ejector rod, and push the stick to push the stuck capsule down 7 The guide plate in the mold is worn, which affects the low rate of capsule fitting Replace the new mold or loosen the positioning on both sides, fasten the positioning nails, change the capsule shape or wet, and replace the capsule shell