Automatic aluminum-plastic blister packaging production line daily maintenance and maintenance methods

Automatic aluminum-plastic blister packaging production line is suitable for various specifications of rubber race, plain piece, fine agricultural piece
.

Aluminum-plastic packaging of small foods such as latex and conjugated tablets, chocolate beans, and flavors
.

Automatic aluminum-plastic blister packaging production line daily maintenance and maintenance is also very important, correct maintenance and maintenance can reduce equipment failure, prolong the service life
of equipment.

So how to maintain and maintain the automatic aluminum-plastic blister packaging production line? Today Xiaobian will take you to understand it
.

1, aluminum-plastic blister machine should be wiped, cleaned, kept clean
.

2.
Frequently check the operation of the aluminum-plastic packaging machine and deal with
the problems in time.

3.
In accordance with the lubrication requirements of the flatbed aluminum-plastic blister packaging machine, lubricate the equipment on time 4, and the cooling parts of the automatic blister machine should not be cut off
when the automatic blister machine is working.

Water supply before start-up, and then heat the heating components; When production is terminated, the water supply
is stopped after the heated part reaches room temperature.

5.
The surface of the heat sealing roller of the automatic blister packing machine should be kept clean, and the attachment should be removed with a fine copper wire brush in the heated
state.

At the same time, the operator needs to pay attention to the amplitude of the operation and the distance between the hand, arm and body and the heating roller to avoid burns
.

6.
After the work is completed, the power supply is cut off first, and the heating components are cooled to room temperature, and then the water source and gas source
are turned off.

7.
When the automatic aluminum-plastic blister packaging machine abrasive is used or stored, it should not be bumped and scratched, and should not be in contact
with corrosive materials.

8.
When the equipment is not used for a long time, the accumulated water in the waterway and the gas circuit should be blown out with compressed air, and each part should be oiled and plastic
covered.