Cleaning of the waterway system of the walk-in constant temperature and humidity test chamber

Everyone may not know much about the waterway of the constant temperature and humidity test box, and rarely go to clean up, Liuqin Technology will talk about the waterway cleaning
of the constant temperature and humidity test box.

Open the sealing plate on the right side of the device, the waterway on the right and the circuit system
on the left.

The waterway system is the key to the humidity of the test chamber, and daily maintenance is also necessary
.

?1.
Open and turn off the total power supply of the machine room door of the constant temperature and humidity test box; 2.
Twist the drain valve and shoot the water back into the bucket; 3.
Pull out the return pipe, pull out the pumping motor and power connector; 4.
Press the water outlet with your hand when there is a leakage at the outlet of the pumping motor and quickly pour the water from the bucket; 5.
Return to the original position after cleaning the various components of the waterway; 6.
Put distilled water or pure water into the bucket and turn off the drain valve; 7.
Turn on the main power supply, and the waterway will run
again.

Although the screw is small, its role is incalculable, and it is an indispensable part
of the entire machine.

Each component of the test chamber is indispensable, the daily maintenance of the components is done, and the constant temperature and humidity test chamber can work
normally.