Common faults and solutions in the use of powder sub loading machine

Powder sub packaging machine is widely used in automatic production of food, pharmaceutical, daily chemical and other products This system is specially customized according to the bottle type of customers Any mechanical equipment in use, there are inevitable failures, powder sub loading machine is no exception In the process of using powder sub loading machine, it may cause malfunction due to operation error, wear of parts, material pollution and so on Therefore, the operators of powder sub loading machine should accumulate more experience of fault maintenance at ordinary times, so that when they encounter problems, they can solve them in Z fast time, so that the equipment can be restored to normal use as soon as possible Common faults and troubleshooting methods in the use of powder sub loading machine: 1 When the machine is just started, replaced or re selected for sub loading speed, the error value of the first few packages may exceed 0.2g That's the computer testing the quality of your powder Please don't worry The occasionally overweight phenomenon in the subpackage process may be that you have too coarse powder Please pick out the coarse powder and adjust the subpackage speed of different materials according to the prompts in Article 4 of "use steps" 2 If the sound is too loud when the equipment is to work, please confirm whether the safety screw at the bottom of the machine has been removed, and whether the workbench on which the equipment is placed is flat and hard (Note: the instability of the workbench will affect the degree of the equipment) 3 In the process of sub loading, if there is any shortage of materials or blockage, the machine will send out an alarm tone of "Di, Di, Di", and then the machine will stop working and enter the standby state Please check the storage capacity If there is a lack of material, please add it and continue the sub loading If there is a blockage, it may be that your material is too long or wet, which causes the blockage of the feeding port Please open the inspection port on the top of the machine, clean up the blockage and replace it, and then sub load again 4 In case of inaccurate weight during sub assembly, please check whether the machine or working table is placed stably or connected to other electrical equipment that may cause vibration.