Constant temperature and humidity test chamber installation knowledge

After the constant temperature and humidity test box is bought, is it necessary to use the power immediately? Of course not, consumers who have just bought back a constant temperature and humidity test chamber need to do a lot of
things.

First, choose the right placement.
The constant temperature and humidity test box should be placed in a ventilated place to facilitate heat dissipation, thereby increasing the refrigeration capacity of the test chamber, generally requiring the distance between the constant temperature and humidity test box and the surrounding wall to be no less than 10 cm
.

Second: carefully read the instructions Before use, the user should carefully read the accompanying product instructions and check the various components
of the constant temperature and humidity test chamber.

Constant temperature and humidity test chamber using the power supply is mostly 380V, 50±0.
5Hz, normal operation, voltage fluctuations allowed between ± 10, if the fluctuation is large or high and low, will affect the normal operation of the compressor, and even burn the compressor
.

Three: electrical safety can not forget that the constant temperature and humidity test chamber should be connected separately, and can not share a power supply
with other equipment.

Pay attention to protect the insulation layer of the power cord, do not re-voltage the wire, and do not change or lengthen the power cord
at will.

Fourth, after checking that there is no mistake, the constant temperature and humidity test box should be left for half an hour, turn on the power supply, carefully listen to whether the sound of the compressor is normal when starting and running, if the noise is large, you should check the electricity, whether the constant temperature and humidity test box is placed smoothly, whether the pipelines are in contact, and make corresponding adjustments
.

If there is a large abnormal sound, the power should be cut off immediately and the manufacturer should be contacted
.

Fifth: when the new machine running-in begins to use, it is necessary to reduce the load and run, because the moving parts of the new machine have a running-in process
.

After a period of operation, a large number of them are added, which can extend the life
of the constant temperature and humidity test chamber.