Correct installation of double glass reaction kettle and precautions

Install the double glass reaction kettle, first open the package, and check whether the main accessories of the machine are complete according to the packing list Assemble the frame with stainless steel pipe and fixings as shown in the attached figure Install the electrical box on the top of the right rear upright post, screw in the screws, and insert the seven core plug The vacuum gauge is installed at the left rear end, and the screw can be tightened According to the use height of the double glass reaction kettle, fix the round bracket of the kettle on the vertical rod slider, place the kettle on the bracket, use the semicircle hoop to fix the neck of the kettle, insert the vertical rod slider, tighten the fixing screws after closing, and pay attention to the verticality of the main body of the double glass reaction kettle during installation The stir bar is fixed on the gear ring chuck of the main shaft of the motor, the stirring rod passes through the middle of the cover to rotate the bearing, tightens the special connector, then adjusts the position of the motor, and concentrates on the vertical concentricity The slide block on the vertical bar is a stainless steel multi-purpose clamp for fixing and adjusting different directions and heights When installing the double glass reaction kettle, it must be cleaned, and the joints should be coated with vaseline to prevent the glass from locking, and then coated with vacuum grease to prevent air leakage Press the fixed device of universal wheel to mix If the mixing is stable, the debugging is good Before using the double glass reaction kettle, carefully check the instrument, whether the glass bottle is damaged, whether the interfaces are consistent, and pay attention to handle with care Wipe the joints with a soft cloth (instead of napkin), and then apply a little vacuum grease (the vacuum grease must be covered after use to prevent the lime sand from entering.) Each interface shall not be tightened too tightly It shall be loosened regularly to avoid long-term locking leading to connector seizure First, turn on the power switch, and then let the machine run from slow to fast When the machine is stopped, make the machine stop, and then turn off the switch The polytetrafluoroethylene switches at all places shall not be over tightened, which is easy to damage the glass After each use, the double glass reaction kettle must be wiped with a soft cloth to clean all kinds of oil stains, stains and solvent residues left on the surface of the machine and keep it clean After the machine is stopped, loosen the PTFE switches, and the PTFE piston will be deformed if it is still in working state for a long time Clean the sealing ring regularly by removing the sealing ring, checking whether there is dirt on the shaft, wiping it with a soft cloth, then applying a little vacuum grease, and then refitting it to keep the shaft and the sealing ring smooth The electrical part shall not be allowed to enter into water, and shall not be damped Original accessories must be purchased Using other accessories at will will cause fatal damage to the machine When doing any repair or inspection to the machine, be sure to cut off the power supply and water source first Note: double glass reaction kettle belongs to fragile product, please handle it carefully when using This is company information, no reprint.