Disassembly method of single stamping machine parts

The tablet press is a machine for pressing dry granular or powdery materials into tablets through a mold The single tablet press is a small bench type electric continuous tablet press The disassembly method of the machine parts is as follows: Disassembly of the middle formwork base plate: take out the powder baffle, take down the hopper, screw out the feeder fastening screw, screw down the feeder fixing stud and spring, take down the feeder, screw down the fixing screw and spring washer of the middle formwork base plate, and then take down the middle formwork base plate Disassembly of lower punch core rod: unscrew the lower punch fixed screw, butterfly screw and gear press plate to turn the adjusting gear, so that the lower punch core rod can be lowered and taken out from the bottom hole of the machine body Disassembly of upper punching core rod: loosen the lock nut of the connecting rod, turn the upper punching core rod to separate it from the connecting rod, turn the hand wheel to raise the eccentric wheel housing to the Zui high position, turn the eccentric connecting shell to swing the connecting rod to the front upper part, and then the upper punching core rod can be pulled out from the upper part of the mold base hole Disassembly of main shaft: two persons shall be responsible for the disassembly of main shaft First remove the large pulley, then screw down the nut to remove the lever, lever shaft and filling roller Remove the protective cover, screw out the screws and washers, and knock the non working surface inside the big gear with a wooden hammer Remove it, then knock the shaft end with a wooden hammer and a copper rod, hold the other end of the shaft firmly and hold the eccentric wheel shell, and slowly remove the main shaft Disassembly of large pulley, pinion and axle shaft: press down the V-belt, screw down the right end nut and washer of axle shaft, hold the large pulley together with the pinion and axle shaft by hand, and then pull out the axle shaft from the wheel hole Connecting rod removal: first remove the upper punch core rod, then remove the steel wire retaining ring on the connecting rod pin, take out the connecting rod pin, and then remove the connecting rod.