Have you ever encountered these problems when using the oral liquid sealing machine?

Have you ever encountered these problems when using the oral liquid sealing machine? With the development of industrial technology, industrial automation has become a trend Now the enterprise starts to use automatic packaging machinery, machinery is more than manual, but it is inevitable that there will be problems in the process of mechanical operation Youdoneng has summarized many common problems and daily maintenance of packaging machinery for you Today, I have summarized the common problems and basic solutions of oral liquid sealing machine for you, hoping to help you Help First of all, it is a relatively simple problem When the oral liquid sealer is running, the speed is inconsistent, and the back panel of the oral liquid sealer can be disassembled when it goes on and off If it is found that the connection between the motor gearbox and the shaft rod is loose or falling off, fix the screw again to make it fit If the problem can not be solved, it may be because the main motor is operated by carbon brush contact, so if the wear is particularly serious, and the slip ring is not fully contacted or the friction is not good, the oral liquid sealing machine can not work continuously, at this time, only the same type of carbon brush is needed to solve the problem In addition, there are irregular marks or bubbles at the product seal, which are also common faults Although it will not leak the inner package, it will affect the quality of the article This kind of failure of the oral liquid sealing machine may be caused by the use of the equipment for a long time and the sticking of plastic chips or dust and other dirt at high temperature, which will cause the phenomenon of uneven and unsmooth high temperature belt, uneven heating at the sealing position and bubbles after the cold pressing wheel At this time, the high-temperature belt can be replaced or cleaned to eliminate the fault Sometimes the uneven concave and convex marks of the cold pressing rubber wheel arrangement will also be reflected on the packaging goods At this time, there will be many obvious marks at the seal To ensure the beautiful packaging, the equipment needs to be replaced   When the sealing temperature cannot be adjusted according to the actual needs, the temperature of the equipment cannot be well controlled This fault is mainly manifested in the failure of the thermometer The sealing place is easy to be burnt or the sealing is not firm, the sealing is easy to be deformed, and the effect is very ugly The reason for this situation is that the thermometer is damaged, needs to be repaired, or the thermocouple is damaged, which is not normal When the temperature is sensed and then transmitted to the thermometer, the thermocouple needs to be replaced If these problems can not be solved, it is possible that the composite material itself is not of good quality and the bearing temperature caused by the change of heat sealing coefficient is not the same.