How do weak wires in the home be buried and installed?

China Paint Online News Information
home decoration will use a lot of wire and cable, in addition to the necessary power supply wires, there are many weak wires such as: telephone lines, network lines, television signal lines, etc. also need to be installed, in order to make the whole home will not appear random lines affect beautiful, the general home weak wires are installed in the dark,
and home weak wire buried installation how to carry out?
see what you say below!
1, determine the location of the weak wire indoor access point:
In this link, the owner needs to tell the designer their usage habits and functional needs, such as installing a TV in the bedroom, you need to install the tv signal cable interface on the bedroom wall;
2, bullet line:
bullet line is the use of a stained line, bounced on the ground or on the wall, the role is used to determine the weak wire from the weak box to the access point between the location of the line, for the later buried line to provide reference.
3, shaving groove:
according to the path of the line, in the wall artificially carved out of the wire groove used to bury the pipe, it is important to note that the shaving groove must not destroy the steel bar inside the wall.
4, pre-buried lines:
in the process of dark buried lines, it is strictly prohibited to bare wires directly buried in the wall, so the need for pipelines.
5, start through the line:
will be buried in the television signal line, telephone line, network cable, etc. from the weak power box to the pipeline, through the pipeline, until the final wall of the interface.
6, acceptance line is smooth:
after the completion of the line, you need to use the meter and other equipment to wear the wire acceptance, to see if the line is clear, whether there is a break point or short circuit.
7, repair the wall:
the overall decoration project is completed, in the wall of the weak wire interface to install the corresponding panel. Cover the project. Buried pipe, after the line, need to cover the shaving groove, for example, for the wall shaving groove, need to use seam gypsum to close the line groove, and then with the seam belt attached, and then carry out the later wall decoration, for the ground shaving groove, the application of cement mortar to fill the groove and find flat, the next normal floor or floor tile.
e.g. above is the main installation method and steps of the home weak wire
, although the steps are very simple, but in the installation process also need to pay attention to its detail quality, otherwise the use of the home weak wire function although achieved, but its walls or uneven ground or repair not in place will greatly affect the beauty of the whole home Oh!