How to solve the common problems of labeling machine

The common problems of the labeling machine are solved according to the following methods: 1.
What should I do when the power is suddenly cut off and restarted? Restart the labeling machine after clearing the bottles stuck on the conveyor belt and clearing the unfinished labels
.

And try to paste before mass production
.

 2.
After changing the label, the labeling position has changed, what should I do? Please reset the stop position parameter until it is in the proper position
.

3.
What should I do if the bid-receiving wheel does not move? Please check whether the drive belt of the take-up wheel is loose
.

 4.
What should I do if the bidding servo is abnormally alarmed? Check whether the wiring head of the servo motor is loose, and check whether the wiring terminal of the information signal wire of the servo motor is loose
.

 5.
What should I do if the inverter alarms abnormally? The equipment has an abnormal load, please remove the fault, and then restart the power supply
.

 6.
There is a deviation in the labeling, what should I do? Check whether the installation position of the inspection object photoelectric is reasonable; Check whether the stop position of the label is accurate.
If the stop position of the label is not accurate, please press the roller pressing the label
.

 7.
What should I do if the labeling is skewed? Check if the bottle is vertical, if not, please reset the speed of the bottle pressing belt to match the conveying speed
.

Check whether the stripping board is vertical
.

 8.
What should I do if there are wrinkles and bubbles after labeling? Re-adjust the squeegee to increase or reduce the force of the squeegee, or change the squeegee angle to eliminate wrinkles on the label
.

 9.
What should I do if the label is missing? Check whether the photoelectricity of the inspection mark is normal; Check whether the bottles are not separated by a distance
.

 10.
What should I do if the label cannot be attached? Check whether the photoelectricity of the inspection object is abnormal
.

 11.
How to solve the problem of broken standard when the machine is running? Check whether the quality of the bottom tape of the label meets the industry requirements; Check whether the string labeling path of the label is correct
.

 12.
What material are the labels used in your equipment? Roll self-adhesive labels
.

Transparent labels, or opaque labels can be used
.