Improve the efficiency of coating production line from the perspective of coating hangers

Starting from the coating of hanging utensils, improving the utilization rate of hanging utensils to improve the production efficiency of the production line can be improved from the following three routes: (1) complete set of hanging appliances - single piece of hanging appliances When the production line was first introduced from Japan, all the hanging appliances were copied from Japan The hanging appliances for painting were also designed to be suitable for the whole set of production Generally, one hanging appliance can be used for a set of air conditioning shell This kind of hanging device is very effective in the ideal production organization state, but in the actual production, most of the workpieces cannot be prepared in complete set, so there are often many hanging points idle on the hanging device For this reason, the complete set of hanging appliances is changed into a single piece of hanging appliances, which improves the effective utilization rate of hanging appliances   (2) special hanging utensils - Dual hanging utensils After changing from a complete set of hanging utensils to a single piece of hanging utensils, although the effective utilization rate of hanging utensils has been improved, with the increase of production varieties, the problem of frequent replacement of hanging utensils in the production process soon exposed Considering the convenience of the use process, after a large number of design attempts, most of the hanging utensils have been improved to dual hanging utensils, one hanging The fixture can be used in several workpieces, so that the problem of frequent replacement of the fixture in the production process has been solved   (3) number of hangers: 2 or 46-8 or 16 In the process of the above two improvements, through the scientific design of the hanger, under the condition of ensuring that the load-bearing of the hanger is not exceeded, the hanging point of a single hanger is increased, thus greatly improving the effective utilization rate of the hanger, and some even increase the utilization rate several times, so as to make the actual production capacity of the coating line body It has greatly broken through the design and production capacity Through the improvement of the above three lines, the production efficiency and production capacity of the coating production line are greatly improved, so that the coating production is no longer the bottleneck factor restricting the expansion of production