Inspection of the installation of ultrasonic vibration sieve

ultrasonic vibration sieve is to convert 220v, 50HZ or 110v, 60HZ of electrical energy into 38KHZ of high-frequency electrical energy, input ultrasonic transducer, it into 38KHZ mechanical vibration, so as to achieve the purpose of sieve and cleanThe modified system in the traditional vibration sieve on the basis of the introduction of a low amplitude, high frequency ultrasonic vibration wave (mechanical wave) in the screen network overlay a high frequency low amplitude ultrasonic vibrator, ultra-fine powder body to accept huge ultrasonic acceleration, so that the material on the sieve surface always maintain a suspended state, so as to inhibit adhesion, friction, flat drop, and other blocking factorsSolved the problem of strong adsorption, easy reunion, high static electricity, high fine, high density, light proportion and so on, so that ultra-fine powder screening is no longer difficulta small editor to briefly introduce the installation of ultrasonic vibration sieve inspection matters, as follows:1, in accordance with the ultrasonic generator cable identification, directly insert the interface and lock, so that the ultrasonic generator power supply and the screen machine ultrasonic interface correctly connected2, the ultrasonic generator power on the fine-tuning twist to Zui small, open the ultrasonic generator power switch, investigate the current meter for anomalies, (under normal circumstances, the current should be less than 200mA)3, check and debug three metavibration screening filter, and to make the material run track to reach the standard running track4, run three metavibration screening filter (cyclone sieve), slightly sprinkle material and fine-tune the ultrasonic generator power to fine-tune twisting, so that the screen to reach an ideal situation(Current should be less than 200mA)5, in the case of ultrasonic vibration sieve normal, you can evenly feed and then into normal operation