Instructions for use of powder filling machine

The powder filling machine is suitable for packaging granules, powder medicines, sugar, and other granules
.
The equipment has a wide range of applications and is suitable for packaging in
medicine, food, chemicals, pesticides, etc.
It is a popular equipment in the packaging industry now.
The single powder filling machine is controlled by PLC, which makes the operation of the equipment easier, the adjustment is convenient, and the degree of automation is high .
All stainless steel sealed body, anti-corrosion and dust-proof .
The exterior is beautiful and generous, the equipment is easy to maintain, and meets GMP requirements .
In fact, this equipment is complex and complicated, simple and simple, mainly depends on whether the operator will use it, and then I will show you the instructions for use of the powder filling machine .
The metering method uses the number of rotations of the screw to measure the weight of the material; the filling machine automatically feeds the material through the material level sensor and the matching screw feeder .
1.
The filling method of the filling machine can be selected in two ways: manual and automatic; when the machine is in use, the vibration (stirring) mode of the operation interface must be turned on for both manual and automatic methods, which can prevent the machine from running.
When unloading, the material in the barrel forms a cavity, resulting in inconsistent weight .
2.
The time setting of the vibration mode is determined according to the actual cutting time .
 　　3.
If the powder filling machine is set to automatic filling mode, the automatic delay time of the operation interface refers to the interval time between unloading and the second unloading; the automatic delay time should be greater than each bagging, unloading and Time for the second bagging! 4.
Setting of filling weight: the weight of filling is obtained by adjusting the number of turns; the number of turns is proportional to the weight of the material; let me give you a few easy-to-understand examples, then you need to adjust the number of turns to change.
small until it is adjusted to a suitable state .
 　　5.
The power of the screw feeder must be obtained from the filling machine; it is strictly forbidden to directly connect it to other power sources! The screw feeder itself has the functions of automatic feeding, automatic unloading and overload protection; when the screw feeder automatically feeds and the powder reaches the material level sensor, the feeder stops automatically; when the powder is lower than the material level sensor , the feeding machine will be delayed for 10 seconds before automatic feeding; this function will be cycled during normal production; if there are sundries, lines, etc.
in the middle of the powder material, the feeding machine will be blocked, and the feeding machine will be overloaded due to increased load.
When the overload function is enabled, the feeding machine will automatically stop; when this happens, the main power supply should be turned off, the sundries mixed in the powder materials should be cleaned up, and then the feeding machine will be restarted; the powder filling machine will stop production , When the powder in the pipeline of the screw feeder needs to be cleaned, the function switch of the feeder should be rotated, and then the discharge port at the lower end of the feeder should be opened to discharge!