Introduction and characteristics of mixer

Mixer is a kind of mechanical equipment which uses mechanical force and gravity to mix two or more materials evenly In the process of mixing, the contact surface area of materials can also be increased to promote chemical reaction and physical change The commonly used mixers are divided into four categories: gas and low viscosity liquid mixers, medium and high viscosity liquid and paste mixers, and powder and granular solid material mixers The working principle of the three maintenance swing mixer is different from that of the traditional rotary mixer It makes a unique translation, rotation, rock and roll movement in the three-dimensional space of the cube, so that the material in the mixing cylinder is in "rotation flow translation"- The so-called turbula state, which is a complex motion state such as "reverse falling body", generates an alternating pulse to continuously push the material, and the turbulence generated by the motion has a varying energy gradient, so that the particles in the mixed material have an impossible motion state, and the particles constantly change their positions in the frequent motion diffusion, resulting in a satisfactory mixing effect Fruit The three-dimensional swinging mixer consists of frame, drive system, three-dimensional motion mechanism, mixing cylinder and electrical control system The mixing cylinder in direct contact with the material is made of stainless steel, and the inner wall of the cylinder is precisely polished Series three-dimensional swing is a new material mixer widely used in pharmaceutical, chemical, food, light industry and scientific research units The utility model can mix the powder or granule materials with good flow performance, so that the mixed materials can achieve good effect Performance characteristics: 1 It has multi-directional movement, so that there are many mixing points in the barrel, and the mixing effect is significant, and the mixing uniformity is higher than that of the general mixer; 2 The inner wall of the mixing barrel of the three-dimensional swing mixer is designed to be precisely polished; 1 The machine is unloaded, loaded and tested before leaving the factory It can be delivered only after normal operation to meet the user's safe use 2 Transportation mode: 600 L (including 600 type) shall be delivered from the factory without foundation and bolts; for more than 600 L, it shall be transported separately with foundation and bolts 3 Operation 1 The machine adopts electromagnetic speed regulation (or frequency converter speed regulation) Before starting up, connect the main power supply, the power indicator light is on, then start the motor button, then start the on-off switch on the speed regulation panel (the frequency converter can press the touch button), the indicator light is on, and then slowly rotate it to reach the normal mixing speed; 2 If the user needs Temple mixing time, this content shall be formulated in the contract Our factory may install time relay to enable the user to specify mixing time according to the mixing requirements of materials 3 After mixing, turn off the machine according to the starting sequence If the blanking is not ideal, click the button to meet the blanking requirements 8、 Note 1 The mixing of this machine is three-dimensional space mixing Add safety protection bar within the effective range of the material cylinder to avoid life safety accidents Before starting the machine, do not stand in front of the cylinder to avoid accidents; 2 During loading and unloading, the electric power of the equipment must be shut down to prevent the electrical failure, causing unnecessary accidents;