Light analysis of the operation of the vacuum box to note.

vacuum box group is used in powder, colloid and other high gas content of objects degassing, with the rapid degassing rate, high degree of automation and other characteristics of machinery and equipmentThe equipment consists of a belt conveyor, vacuum cover, vacuum pump, pneumatic lift system, automatic detection and control system and other partsa brief introduction to the use of vacuum box needs to be aware of, as follows:1, remove the processed items torn, such as handling flammable items, must wait for the temperature to cool below the point of combustion, before putting into the air, so as to avoid oxidation reaction caused by combustion2, vacuum box without explosion-proof device, not put in explosive items drying3, vacuum tank does not need continuous pumping use, should first close the vacuum valve, and then close the vacuum pump power supply, otherwise the vacuum pump oil to pour into the box4, the vacuum box and the vacuum pump between the good cross filter to prevent the wet body from entering the vacuum pump5, this equipment should be installed a special air switch6, not necessary, do not open the edge door at will, so as not to damage the electrical system7, when removing the treated items, such as handling flammable items, must wait for the temperature to cool below the ignition point before it can be put into the air, so as not to cause combustion caused by oxidation reaction8, the vacuum box housing must be effectively grounded to ensure safe use9, electrical insulation is intact, the equipment housing must have a reliable protection ground or protection ground zero10, the equipment does not have explosion-proof device, shall not be put into explosive items dry11, vacuum pump should often replace the vacuum pump oil.