Matters needing attention and common trouble analysis when changing the belt of the belt sealing machine

Precautions when replacing the belt of the belt sealer: the application of the belt sealer is quite extensive, and the installation and replacement of the belt is one of the essential operations There are also potential safety hazards in the installation process If you don't pay attention to it, you may be injured Therefore, Shanghai Zongyi shares with you the precautions when replacing the belt of the automatic sealer: 1 When replacing the belt, pay special attention to the position of the cutter When threading the belt, the operator's hand should not move too much Be careful to avoid being hurt by the cutter; 2 When wearing the tape, when the tape head must be wrinkled, the wrinkled part must be removed During the removal process, the tape cannot be pulled hard, and the hand force cannot be too strong, because the tape is a material easy to crack, if the force is too strong, the hand is easy to be bruised; 3 When replacing the tape, please note that the adhesive surface of the tape must be facing The good or bad installation of the sealing tape is an important factor affecting the sealing effect Therefore, in order to ensure the sealing effect and the safety of the operators, please pay attention to the above matters during the installation! Analysis of common faults of belt sealer: * The action of clamping nails is too slow or the stroke of clamping nails is not enough: the bolts are loose, the front buckle or the inner plate of the board machine are worn, and the bolts can be tightened at this time, Pay attention to the correct position of the front buckle, or replace the front buckle or the inner plate of the board machine After the above actions are completed, test its functions If the action is slow, fine tune the front buckle down, if the travel is too short, fine tune the front buckle up Second, air leakage at the exhaust port: the switch seat ring or the on-off valve ring is damaged or the piston ring is damaged The ring can be replaced Third, air leakage at the piston rod: the bottom ring of the main body is damaged, and the ring should be replaced at this time; fourth, the transmission ring is loose and cannot be located: the plastic steel strip and the transmission spring are inelastic, remove the plate machine combination, and reinstall the spring tip or replace the plastic steel strip and the transmission spring Fifth, there is air leakage at the trigger: the on-off valve ring or switch seat ring is damaged Replace the ring; some people don't know which sealing machine to buy when they buy it It's good It's cheap It's durable I'll give you some suggestions It is economical, fast and easy to adjust to seal the cartons with instant adhesive tape It can seal the cartons up and down at one time It can also use printing tape to improve the image of the products It can also use the general tape sealing machine with a wide use of Zui These are all from the automatic packaging enterprises The key component of the sealing machine is the driving motor The higher the motor power, the better.