My site, I take charge

The clean workbench is an air purification equipment that provides a local dust-free and sterile working environment.
It can artificially control the discharge of polluted air in the working area through a special filter channel to avoid harm to people and the environment.
It is a safe micro Dedicated workbench
.

It is widely used in laboratories, medical and health care, pharmaceutical and other related industries, and has a good effect on improving process conditions, protecting the health of operators, and improving product quality and output
.

Such a workbench fully explains what is called "my site I call the shots"
.

Before using the clean workbench, irradiate it with ultraviolet light for half an hour to check whether all openable doors and windows around the work area are in the working position
.

The operation takes place in the center of the operating area
.

By design, this is a relatively safe area where regular maintenance is very important
.

Before operation, you should have a preliminary understanding of the experimental materials and the performance and safety level of the equipment used
.

Strictly enforce laboratory safety regulations
.

The safety of using specific pathogens on any clean bench must be assessed
.

If the experimental material will cause environmental pollution to the surrounding environment, it should be avoided in models without exhaust filter plates, as the operation is the same in flowing air
.

No equipment can guarantee the success of the experiment, so skilled operation and clear sterile conditions are very important
.

 　　1.
The intensity of UV lamps should be regularly tested according to the manufacturer's regulations
.

It is recommended to test it once a quarter, and replace it if it fails
.

 　　2.
Raise the bottom edge of the glass door to a suitable height, turn on the fan, and run the cabinet for half an hour before trial operation.
To ensure safe operation, the experimental supplies should be put into the safety cabinet in advance
.

 　　3.
After the workbench is used, lower the bottom edge of the glass door to the bottom, turn on the UV light, and turn off the equipment after more than half an hour
.

 　　4.
Clean and clean the surface of the operation area of ​​the workbench: first wipe the entire surface with a soft cotton cloth dipped in concentrated soap solution, then use another cotton cloth or towel soaked in clean hot water or warm water to wipe the soap bubbles, and then quickly wipe with a dry cloth or towel
.

If the surface of the operating area is contaminated or has marks, wipe it with medical alcohol
.

 　　5.
Cleaning of exterior surfaces and glass doors: Use a non-abrasive household cleaner and wipe with a soft cotton cloth or towel
.