Operating steps of the flip oscillator

1.
Place the sample and extract to be shaken in the vial as required, close the inner lid, tighten the outer cap, and invert the vials to ensure that the solution in the bottle does not leak
.

2.
Turn on the power supply, push the total power switch up, and turn on the instrument power
.

3.
Loading of the vials (1) Push the moving sliding door upwards, turn the rotating device to the appropriate position by hand, turn the handle counterclockwise, loosen the solid bottle device, put the prepared and tightly covered vials into the tray, and tighten the handle
up and down in the direction of the clock.

Screw the fixing nut counterclockwise to the top by hand to prevent the bottle fixing device from loosening
during machine operation.

(2) After the sample vials are loaded, close the movable sliding door, turn on the speed/switch button, and the instrument begins to work
.

After use, you can not forget to maintain and maintain: 1, after each use of the equipment, you should do a good job of cleaning the inside and outside of the equipment; 2, the plating, coating of the equipment should often pay attention to anti-corrosion measures to prevent corrosion, in the outer surface of the equipment can be used car wax glazing; 3, the motor machine needs to be often inspected and cleaned, can not accumulate dust, so as not to affect the normal operation of the motor; When the motor is in operation, if there is a special sound or the surface temperature is abnormal (the temperature rise is greater than 70 ° C), it should be stopped immediately for inspection
.

If the bearing is damaged, it should be replaced in time; If the impeller falls off and loosens, it should be tightened; If the motor positioning fastener is loose and displaced, it should be reset; If there is a lack of lubricating oil, it can be lubricated with calcium sodium-based grease, please pay attention to maintenance
.

We hope that the above content can help you better understand this device
.