Operation instruction of automatic pill making machine for traditional Chinese Medicine

The full-automatic pill making machine for traditional Chinese medicine is suitable for the room with the ambient temperature of - 5 ℃ to 40 ℃, the relative humidity of less than 90%, the voltage amplitude fluctuation of power grid less than 10% of the rated value, and no conductive dust and corrosive metal gas around It can be installed in the plant with sufficient sunlight and clean, without foundation, and it can be leveled For safety, it must be grounded Before starting the automatic Chinese medicine pill making machine, it is necessary to check whether the oil level of the gearbox reaches the standard position; check whether the oil cup on the hopper is filled with edible oil; check whether the pill making machine is aligned and tightened; check whether the liquor cleaning system is smooth and adjust the proper amount Use alcohol to disinfect guide wheel, guide frame, pill making knife, etc Turn on electric heating The striping part shall be idled for 3-5 minutes If there is no abnormality, the material can be fed and the striping can be pushed out Return to a part of the hopper, and open the pelletizing part after the strip is qualified The feeding shall be uniform during operation If it is found that the sliver and pill making are not synchronized, it can be adjusted by the knob The pill making is fast in clockwise direction and slow in anticlockwise direction The size of shot diameter can be achieved by changing different taphole, shot making roller and guide wheel When feeding, do not put foreign matters into the hopper, and do not extend your hand into the upper plane of the hopper, so as to avoid hand injury caused by pressing plate Always check whether there is any abnormality in each part of the machine, and stop the machine for inspection immediately in case of any abnormality After the use of the automatic pill making machine of traditional Chinese medicine, the main switch and other switches are turned off When removing the strip outlet, the electric heating cover and the unloading head, the hook shaped handle (special) can be used, and then the bracket and the propeller can be pulled out Disassemble the upper part of the hopper and clean the two flap shafts, and apply edible oil after cleaning When reusing, use alcohol to remove oil and disinfect all parts The oil in the reducer shall be kept on the oil free mark, and the waste oil shall be discharged and replaced in normal operation for two to five person months Add edible oil to the oil cup on the hopper three times per shift, and add proper amount of oil to other gear opening sprocket points.