Operation manual of cyclone separation and crushing equipment

Installation instructions for cyclone separation and crushing equipment ◆ connect the power supply correctly Before starting, check whether there are any abnormal sundries in the machine room ◆ turn on the machine and check whether the turning direction of the cutter is correct If the direction is reversed, please change the wiring sequence of the three-phase power line; after confirming that the turning direction of the cutter is correct, start the idling for 10 minutes, and then put into production after everything is normal ◆ it is forbidden to put iron and other hard materials into the crushing chamber ◆ in case of any abnormal sound, stop the machine immediately, check the cause, and restart the machine after troubleshooting ◆ it is recommended to install the machine in an independent workplace Maintenance of cyclone separation and pulverizing equipment: the mechanical starting motor shall be oriented to the ventilation position to ensure the heat emission of the motor and extend the life of the motor ◆ check the cutter bolts regularly After a week of new use, tighten the cutter bolts with special tools to enhance the fixity between the blade and the tool holder ◆ rolling bearing with seat: add grease to the bearing oil nozzle every other period of time to ensure the lubrication between rolling bearings ◆ according to the use, check the moving blade regularly to ensure the sharpness of the moving blade and reduce unnecessary damage of other parts caused by the blunt blade ◆ before the second start-up, the remaining debris in the machine room should be removed to reduce the starting resistance and the starting load of the motor Remove the inertia wheel cover regularly and remove the ash outlet under the belt pulley ◆ when replacing the tool, keep the gap between the moving tool and the fixed tool ◆ regularly check whether the belt is loose If the belt is loose, loosen the fixing bolts of the motor, and use special tools to move the motor outward until the belt is tightened Precautions for use of cyclone separation and crushing equipment ◆ before starting the crusher, turn on the main power switch to confirm power on Open the circulating cooling water again and confirm the water supply ◆ before starting the crusher, open the extractor for 5 minutes, then open the discharge valve of the storage barrel, discharge the crushed materials in the storage barrel, and then press the start button of the crusher to start the crusher ◆ the charging amount in the storage barrel should not be too much When the charging amount reaches 1 / 2 of the barrel, it must be discharged Otherwise, too much material storage will lead to the difficulty of fan pumping, the fan can not discharge the crushed materials in the crusher, which may cause the fan motor to burn, and the crusher is stuck and other serious problems ◆ when the crusher is shut down, please shut down the crusher first and wait for 10 minutes Evacuate the crushed material in the crusher, and then turn off the power supply of the extractor after discharging the material in the storage barrel ◆ please repeat the above item 1 to operate as required before starting the machine again ◆ the dust in the bag on the storage barrel needs to be cleaned It is recommended to clean it every three days to keep the bag ventilated smoothly ◆ it is recommended to add bearing grease every two months First, turn off circulating cooling water, then unscrew four bolts on the bearing cover and open the bearing cover for oil filling After filling the grease, please pay attention to tightening the bolts of the bearing cover.