Operation method and precautions of multifunctional wire labeling machine

Multifunctional wire labeling machine is a special equipment for labeling wires and plug power lines It is a newly developed intelligent automation equipment for wire and plug power line processing industry It is mainly used to paste bar code labels, warning labels, instruction labels and other volumes on power lines, data lines, DC power supply lines, such as wires, laptops, desktops, printers, digital cameras, cameras, PDAs, mobile phones, etc., of which bar code label Z is common It's very important to operate the multi-functional wire labeler correctly Today's editor will introduce the operation method and precautions of the multi-functional wire labeler: operation instruction 1) Place the label roll on the label disc according to the normal labeling direction and fix it 2) lead out the label paper tape from the label disk and wind it on each guide roller in sequence (operate as shown in the attached figure on page 5); 3) wind out the paper tape from the guide roller and pass through the optical fiber sensor to the label work area At this time, release the tape pressing film and thread the paper tape from the bottom of the label stripping plate at the junction with the label wheel 4) After the paper tape comes out of the label work area, it goes around the guide roller in the opposite direction and goes through the middle of the belt pulley and the belt pulley, and comes out around the belt pulley Take off the card belt rod, wind the bottom paper belt neatly and firmly on the take-up pulley and put on the card belt rod to press; 5) manually and slowly roll up the loose paper belt, and after a certain tension, twist the pressure pulley rod to lock the pressure pulley Observe whether the label belt is always in a horizontal state in the process of detour, adjust the ring of each stop mark and properly lock the tape pressing film, so as to maintain a stable belt feeding, even and flat labeling Note: 1 The input power voltage of the machine is AC 220V / 50Hz Do not connect to the high voltage source to prevent the machine from burning 2 The air pressure of the air source is greater than 0.6MPa (6kgf / cm) Although the machine is equipped with an oil-water separator, the air source Zui is well filtered and dried to avoid frequent manual drainage and soiling of the machine and workplace; or due to the untimely drainage, water flows into the solenoid valve and cylinder, reducing its service life Press the water outlet of oil-water separator upward to drain water It is recommended to set a section of hose on the water outlet 3 The rated current of this machine is 5 amperes (), and fuses exceeding this rating shall not be used If the fuse often blows, the machine is faulty and should be repaired 4 If the machine is out of service for a long time, it should be electrified for about 30 minutes before use 5 Check whether there is disconnection or leakage due to frequent movement of foot switch wiring 6 Handle with care and prevent hand clamping!