Operation process and precautions of pulverizer

Operation process of the crusher: 1 Before use, check whether all fasteners of the crusher are tightened and whether the belt is tensioned 2 The operation direction of the main shaft of the crusher must conform to the arrow direction shown on the protective cover, otherwise the machine will be damaged and personal injury may be caused 3 Check whether the electrical appliances of the crusher are complete 4 Check whether there are metal and other hard sundries in the Pulverizer's crushing room, otherwise the cutter will be damaged and the machine operation will be affected 5 Regularly check whether the cutter and screen are damaged, and replace them immediately if any 6 The purity of materials must be checked before crushing, and no metal and hard sundries are allowed to mix in, so as to avoid damaging the cutter or causing combustion and other accidents 7 The oil cup on the crusher shall be filled with lubricating oil frequently to ensure the normal operation of the machine 8 When the crusher is in use, it will experience slight vibration It is necessary to tighten the connecting handle of the cover to avoid accidents 9 Stop feeding before shutdown If it is not in use, it is necessary to clear the matters needing attention: 1 For the personal safety of the user, the power supply must be grounded 2 The comminuted material must be dry, and it is not suitable to process the traditional Chinese medicine with damp and grease 3 The crushed medicine shall not exceed half of the capacity of the crushing tank 4 It only takes half a minute to crush the traditional Chinese medicine and one minute to crush the hard medicine 5 The machine can not be used for a long time continuously, and the starting time of each time shall not exceed 5 minutes If the number of processing is large, it should be used at intervals to prevent overheating of bearings and damage to the motor 6 Do not start the switch when the upper cover is open 7 After long-term use, if the carbon brush and blade are seriously worn, they need to be replaced 8 Check the screws of the blade frequently and make sure they are tight.