Pay attention to the details before using the traditional Chinese medicine pill making machine

Before opening the pill making machine of traditional Chinese medicine, we should do a good job of preparation These steps should not be underestimated, because the process before the operation of the pill making machine is not completed, in fact, it has a great harm to the machine It is needless to say that reducing the service life of the machine will lead to the failure or even damage of the pill making machine of traditional Chinese medicine Before opening the pill making machine of traditional Chinese medicine, we need to conduct a comprehensive investigation on the pill making machine First, we need to determine whether the surrounding electricity is safe, whether the circuits of plug and socket are normal, and not because of the circuit problems, there is leakage or short circuit After checking the * item, do not leak out the check oil level, that is to say, the oil level on the gearbox should be in accordance with the standard of the traditional Chinese medicine pill making machine If it does not meet the requirements of the mark, it must be adjusted and improved Then you need to check whether the cooking oil on the hopper has been filled on the oil cup Are they all filled? Then do the parts of the internal machine meet the standards? Before starting, what content should we check for the pill making machine of traditional Chinese medicine? First of all, check whether the shot making machine has been aligned and tightened And whether the alcohol system has been adjusted clearly, appropriately and smoothly Zui is very important to use alcohol to disinfect the guiding frame and the introduction of pill making knife After finishing the above procedures, you can safely open the pill making machine of traditional Chinese medicine for use Generally, we are using Chinese medicine pill making machine When you use the machine, you should pay attention not to start the machine as soon as you turn it on First, after the machine is started, let the outgoing part run for three to five minutes Because you are worried that when you last used the traditional Chinese medicine pill making machine, there are still residual medicines stuck in it, which may cause damage to the machine and may contaminate new medicines If you find no abnormality, you can feed and get Material bar Then try to return the charge to the hopper, not too much, just a part of the charge If the strip is qualified, then the shot making part can be opened again, and it should be noted that the charge should be placed evenly during the operation If you find that the sliver is out of sync with the shot making, you need to adjust the knob to a consistent pace Generally, turning clockwise can speed up the shot making, and turning counterclockwise can slow down the shot making.