Performance and product characteristics of filling and stoppering machine

Performance and product characteristics of filling and stoppering machine It can be equipped with bottle washing, capping, labeling, code spraying, packing and box sealing to form an unmanned filling linkage production line The advantages of the equipment are straight-line filling, which can be applied to a variety of bottle types It is easy to adjust and maintenance free design The metering method adopts stainless steel piston type volume filling, which works continuously, is durable and durable However, the filling and stoppering machine is in operation There will also be faults Let's talk about the common faults and handling methods of the filling and stoppering machine
The filling and stoppering machine appears after the first filling, and four (or five) heads of a group fill at the same time, it must receive the start signal of the second filling From the display screen, there is a "running" display, because the equipment does not detect the start signal during the filling process, which means that another start signal is received at the end of the filling, if not every time, it means interference Signal If the equipment does not break down in the stable period, but the probability of slow filling is high, it needs to be observed on site If the start signal light on PLC is on for a shorter time with the increase of filling speed, the slower and longer the time is, it means that the closer the end time of the start signal is or the time lags behind the filling time, the more likely secondary filling will occur That is to say, when the start signal on our control board disappears, it is easy to be affected by the interference signal and cause the secondary trigger Therefore, it is concluded that the long start signal + interference signal is easy to cause the phenomenon of repeated filling According to different specifications, the filling and stoppering machine needs to adjust the position of synchronous belt driven wheel and driving wheel fixed at the front and back of the mounting base, determine the height position of the suction plate of the stoppering machine, and adjust the gap between the stoppering wheel and the arc fence of the stoppering machine Adjust the centering position between the rubber plug of the suction plug plate and the bottle mouth The positioning height depends on the height between the outlet of the bridge plate of the dryer and the ground Generally, the working surface is required to be 900mm ~ 920mm from the ground If the bottle outlet of the filling and stoppering machine is connected with other equipment, the overall height of the whole line shall be considered The connection between the bottle feeding and bottle handling plate of the filling and stopper machine and the bridge plate of the dryer shall be left and right straight, the transition plate shall be kept flat, and the working platform plate and bottle handling plate of the whole equipment shall be leveled and leveled When installing laminar flow support and plexiglass door, pay attention to parallel and vertical, and keep the gap between the door and the door closed the same The height position of the stopper plate is that the rubber plug can enter the suction plate smoothly, and the gap between the upper part of the rubber plug and the suction plate should be about 0.15mm The front and rear positions of the stopper plate and the suction plate shall ensure that the rubber plug can be fully put into place The gap between the front and rear positions of the outlet of the oscillating bucket and the inlet of the stopper plate is that in normal operation, they do not collide with each other and the smaller the gap is, the better The left and right positions of the outlet of the oscillating bucket and the inlet of the stopper plate must be aligned to ensure that the rubber plug can enter the passage of the stopper plate smoothly The gap between the tongue at the outlet of the oscillation bucket of the filling stopper and the channel surface of the stopper plate shall be equal to the gap of a rubber plug thickness + 0.2mm, so as to ensure that the rubber plug can enter the suction plate smoothly