Sharing of lubrication methods for laboratory swing granulator parts

The laboratory swing granulator is mainly used in medicine, chemical industry, food and other industries to manufacture various specifications of particles After drying, it can be used to press various shaped products The machine can also be used to crush and condense the dry materials into blocks The structure of hopper and pelletizing device is designed according to the principle of convenient installation, cleaning and use All structural materials in contact with materials are made of stainless steel and non-toxic tetrafluoroethylene The vacuum feeding machine ensures the cleanness of products without chemical reaction The lubrication of the machine parts of the laboratory swing granulator is as follows: 1 The small granulator is equipped with an oil meter in the box Before starting up, all oil should be added once, and it can be added according to the temperature rise and operation of each bearing halfway 2 The oil must be stored in the worm gear box for a long time The oil level height of the worm gear is that all the worm gears invade the oil If it is often used, the oil must be replaced every three months There is an oil plug at the bottom, which can be used for oil drainage 3 When filling the small particle machine, do not let the oil spill out of the cup, let alone flow to the surrounding and ground of the machine Because oil is easy to contaminate materials and affect product quality Because part of the work of the vibrating screen of the laboratory swing granulator belongs to the fine operation, such problems can not be avoided during the operation Sometimes, when screening materials, the discharge situation is different, at this time, the material screening can be adjusted by adjusting the upper and lower hammers to achieve better results First of all, we can adjust the additional weight of the vibration motor of the laboratory swing granulator, and install the additional weight on one side of the upper and lower weights (upper and lower eccentric weights), so as to increase the excitation force of the vibrating screen According to the specific gravity of the materials to be screened and the number of layers of the vibrating screen selected, we can appropriately increase and decrease the excitation force and adjust the number of additional weights Secondly, the phase angle of the upper and lower hammers of the vibrating motor can be changed, which changes the residence time and movement track of the material on the screen Moreover, the bottom cylinder of the shaker of the laboratory swing granulator can be opened, the fixed bolts of the lower heavy hammer can be loosened, and the phase angle of the upper and lower heavy hammers can be adjusted in the opposite direction of the outlet of the shaker according to the motion track of the screened materials Then put some materials on the screen of the vibrating screen, let the vibrating screen operate with electricity, and see the movement track of the materials on the screen surface If the separation efficiency, screening rate and handling capacity of the material, the distribution of the material on the screen surface is relatively uniform, the machine can be stopped and then the fixing bolts can be tightened.