Structural characteristics and description of CH Tank Mixer

Structural features: 1 This machine is an integral frame, with solid structure and stable operation The mixing paddle and material contact are all made of stainless steel, which has good corrosion resistance and keeps the quality and cleanness of the mixture without discoloration 2 The transmission mechanism is directly driven by worm and gear, without excessive noise during use, and with enough oil storage, it can get good lubrication 3 The agitator is flexible When changing the material type, only one nut can be removed to take out all blades and clean them thoroughly in the tank 4 This machine is operated by the automatic mechanism controlled by electrical equipment, which is easy to operate and greatly reduces the labor intensity of the operator The mixing and pouring are equipped with a joint pin device to ensure safety Time control is attached Automatic stop in different time to improve material quality Structure description 1 Mixing reducer: this reducer is the main drive mechanism of the mixer, which is located on the right side of the machine When it works, the motor installed in the base drives the worm wheel and worm through the triangle belt, and drives the mixing paddle with a 1:25.5 deceleration The worm gear shaft is a hollow handle and is equipped with a fixed key, which enables the impeller to be installed and disassembled freely There are two ring screws on the top of the reducer, which are used for installation, disassembly and installation A screw is installed on the end cover to adjust the positioning of the mixing paddle, which has been adjusted at the factory, and generally does not need to be adjusted in use 2 Mixing tank: the mixing tank is U-shaped, made of stainless steel and equipped with mixing paddle, which lies on the mixing reducer and the dumping reducer The mixing paddle is a combination of two parts Screw down the hex nut and pull out the central shaft The mixing paddle can be taken out when it moves to the left and right The right end is equipped with a butter cup, which stretches out outside the feeding reducer to lubricate the mixing paddle axis 3 Feeding reducer: the feeding reducer is to control the positioning angle of the mixing tank, which is located on the left side of the machine When it works, the motor installed in the machine base drives the mixing tank to rotate in a certain angle range through the triangle belt, transmission worm and sector worm wheel, so that the mixture can be poured out once 4 Base and motor device: the base is cast as a whole, and the motor is installed on the movable plates on both sides of the base The upper and lower parts of the motor can be adjusted by screws, so that the triangle belt can be tightened to a certain extent and the power transmission can be maintained The middle door behind the base is equipped with electrical appliances The power supply is connected to the change-over switch through the hole under the base The base is equipped with two limit switches to control the rotation angle of the mixed groove 5 Electric control box: this box controls the movement of the machine, which is located on the right side of the machine The front is equipped with ammeter, button switch and red green indicator light When the main switch behind the engine seat is turned on, the red light will be on, indicating that there is power on the line; when the mixing paddle is turned on, the red light will be off and the green light will be on, indicating that the mixing motor is in normal operation, and the ammeter also indicates the load of the motor The operation of the mixing paddle can be divided into continuous and timed operation When the switch is at the continuous position, start the mixing paddle to operate at a fixed time, and then it will stop automatically The mixing time can be adjusted by the time relay on the side of the control box In the continuous operation of the mixing paddle, it is required to start the fixed time, and the switch can be opened at a fixed time At this time, the mixing paddle also stops, and the "on" button of the mixing paddle must be pressed again This is where the time begins In order to protect the operation safety, when the upper opening of the mixing tank leaves the upper cover, all the above movements will stop At this time, the mixing paddle will only operate when the button is pressed "on" When the mixing tank is turned, the button "up" and "down" of the mixing tank can be pressed Note that the two buttons cannot be pressed at the same time The rotation angle of the mixing tank is controlled by the fiber switch on the organic base, and the angle is adjusted by the control boards at both ends of the mixing tank Festival