The difference between two-dimensional and three-dimensional traditional Chinese medicine mixers

The two-dimensional mixer moves in the x-axis and y-axis, while the three-dimensional mixer moves in the XYZ three axis The efficiency and mixing degree of three-dimensional mixer are much higher than that of two-dimensional mixer The two-dimensional mixer is widely used in medicine, chemical industry, food, feed, pesticide and other industries, especially for the mixing of large tonnage solid materials The cylinder of three-dimensional charging is driven by the driving shaft, which makes the compound movement of circular, radial and axial direction, so as to realize the mutual flow, diffusion, accumulation and doping of various materials, and achieve the purpose of uniform mixing This machine is mainly used in pharmaceutical, chemical, food, light industry, electronics High uniformity mixing of powder and granular materials in machinery, mining and metallurgy, national defense industry and scientific research institutions The mixing cylinder of the two-dimensional mixer is in swing at the same time of rotation, so that the materials in the cylinder can be fully mixed, so that the mixer has the characteristics of rapid mixing, large mixing amount and convenient discharging The loading rate of three-dimensional mixer is large, the Zui is up to 80% (only 40% for ordinary mixer), the efficiency is high, and the mixing time is short It is an ideal product in the mixer at present The loading capacity of the general mixer is related to the working capacity of the colter mixer The control of the operation process conditions of the mixer, that is, the control of the material temperature and mixing time, is generally related to the material formula During operation, it is necessary to mix evenly and prevent molecular degradation of materials During operation, the mixed operation process is usually controlled by observing the reading change of the ammeter of the main motor The mixing operation is generally controlled at about 4-8mm As the materials in the mixing process are generally in powder form, slightly granulated Dell materials usually need to be cut with the help of the Throwing Knife of the mixer to facilitate crushing or cutting ① The machine needs to be used frequently The reducer must be replaced with new oil every three months When replacing, the reducer should be cleaned and added with new oil ② The equipment and parts shall be inspected 1-2 times a month The inspection parts are worm gear, worm, bearing and oil seal Whether the operation parts are flexible and whether the fasteners are loose shall be handled in time in case of any abnormality ③ During the use of the machine, if it is found that the machine vibrates abnormally or makes abnormal sound, it shall be stopped immediately for inspection ④ Electrical control parts shall be kept clean and sensitive, and any fault found shall be repaired in time ⑤ The mixing slurry shall be installed and removed gently, stably and gently to avoid deformation and damage ⑥ After the use of the machine, the residual materials of all parts of the machine shall be brushed If the machine is out of service for a long time, it must be wiped and cleaned completely The surface of the machine parts shall be coated with antirust oil and covered with tarpaulin.