The installation and use of the spray dryer peristaltic pump

Spray dryer peristaltic pump installation and use of the use of the method of peristaltic pump to a certain extent will affect the life of the peristaltic pump, in order to extend the life of the peristaltic pump, how to use the peristaltic pump? The new peristaltic pump should be tested before use, because in transit will produce a certain degree of damage to it, affecting the test results, so before the test to let it sit for 3-5 hours, and then test, before testing to check whether the appearance of the peristaltic pump is damaged, wait until the inspection is good before testing according to the instruction manual.
the outdoor environment is bad, will affect the life of the peristaltic pump, so try not to put the peristaltic pump outdoors, if you must use outdoors, with things to block it, to avoid wind and rain.
peristaltic pump pump tube selection, if used for experiments, you can use the whole meter tube, if it is used in production, the level of hygiene requirements are not high, you can use ordinary tube, which can effectively extend the life of the pump pipe, but also reduce the cost input of enterprises.
if the production enterprise needs to use 24 hours a day, the appropriate feeding tube should be selected, because its service life will be longer than the ordinary tube.
if the use of peristaltic pump interval is relatively long, when each time to use, should first add some lubricant at the inside axis of the pump head, play the role of lubrication.
can be selected as long as it is an oily substance.
in order to improve accuracy, each time the pump tube is pressed into the peristaltic pump head, the pump tube can be pulled to the left and right.
multi-channel peristaltic pump can first press the pump tube into the peristaltic pump head, and then appropriately pull the pump tube to the left and right sides, and then adjust the length of each channel pump head on the left and right sides of the tube consistent, which can effectively reduce the error between the channels.
using the peristaltic pump, if the number of turns displayed is always changing, there may be magnetic interference around the peristaltic pump, and it can be restarted elsewhere.
timing metering distribution products, first according to the instructions set all the relevant parameters, the pump will automatically run, peristaltic pump tube can be moved by hand, can also be used on the conveyor belt, to achieve fully automated operation, so that the operation will not only reduce costs, but also improve accuracy.