The operation steps and procedures of the tube centrifuge

1, theof preparation before the operation of the tube centrifuge
(1) When the percentage of impurities or solids contained in the liquid is less than 0.5%, the machine exerts the ideal separation effect, if the percentage is higher than 0.5%, it is recommended to clarify the treatment(2) feed is generally made from a high-level groove, if the viscosity of the liquid, can also be used to pump the feed(3) the determination of import pressure, the pressure of material through the nozzle into the centrifuge depends on the nature of the material, but at least to spray up to half of the drum, if the pressure is too low, then part of the liquid will not enter the drum and from the lower inlet housing overflow outlet, if the pressure is too high to affect the separation quality, but also easy to cause the vibration of the machine(4) the internal diameter of the feed pipe should be large enough to be controlled by valve, the user can determine according to the flow rate and yield(5) separators are equipped with three nozzles of different diameters, the nozzle selection depends on the material separation quality and yield, if the quality is high yield hours, using small nozzles, and vice versa2, tube centrifuge power operation(1) to the separator's motor on the power supply waiting for about 50 seconds, the drum can reach the working speedThe starting current of the motor is generally around 30A(2) machine full speed, before opening the feeding valve, first open the valve to be clarified liquid out of the receiver, the valve opened to the pre-determined flow, liquid clarification, in the separation process do not stop the feeding(3) separation operation, observe whether the liquid flow of the outlet is normal, observe whether the clarification degree meets the clarification requirements, until the liquid at the outlet begins to mix, stop the discharge3, tube centrifuge shutdown(1) before the shutdown must first turn off the feed valve, wait until the liquid tray does not flow liquid, before shutting down, cut off the power supply, free shutdown(2) discharge and cleaning drumand assembly procedures, remove the drum to wear a protective cap, placed on the fixed frame, with a special hand to open the drum bottom shaft, with a pull hook to remove the three-wing plate, with a scraper, shovel will be the drum inside the slag and solids removal, and the pipe centrifuge clean Back to Sohu for more