What is the adjustment method of plane labeling machine

When the plane labeling machine is used, the center line of the label box, the center axis of the label station are tangent to the label paper, the center axis of the label plate form a line at three points, adjust the tangent (0 distance) between the label plate and the label paper, and then move the label box closer to 1mm ~ 2mm The gap between the marking paper in the marking box and the strip on both sides should be between 0.8mm-1mm If the gap is too large, the marking paper will move in the marking box, and there will be an oblique mark If the gap is too small, it will cause the poor pushing of the mark Adjustment of the position of the grabbing hook of the standard box: if the grabbing hooks of the upper, lower, left and right are on the same vertical plane and the pressure is even on the standard paper, the grabbing can be carried out smoothly Adjustment of label supply roller: when there is no label, the label pressing plate can be pressed to the front end of the Zui of the label box and the label is installed, the label near the hook finger of the label cannot be crushed Adjustment method of plane labeling machine: 1 The label must be installed in place, and it is easy to break the label if it is crooked After the label is installed, fix the position with limit ring 2 Adjust the conveying guide strip according to the width of the product to be labeled, and leave enough space of 1mm between the two guide strips and the product The general paper card products use a single-sided guide strip, so you only need to adjust the two ends of the conveyor guide strip to be more even 3 Adjust the measuring eye Tear off a label that is about to enter the area of the electric eye for measuring the mark, press and hold the button on the electric eye for measuring the mark to enter the setting state, pull the label roll with manual traction in the manual interface of the touch screen, make the bottom paper of the tear off label completely pass through the sensing area of the electric eye for measuring the mark, and then press the button on the electric eye for measuring the mark again to confirm the completion of the setting If the optical fiber eye is used to detect the marking eye, the preset value of the output signal on the amplifier shall be set according to the difference between the number of the signal taken by the label on the label roll and the number of the signal taken by the backing paper