Whether the floor of the high temperature aging room of electronic products should be used as a thermal insulation layer

The high temperature aging room of electronic products generally has five thermal insulation walls in the design and production, but the bottom plate/ground does not have thermal insulation layer
.

So, do you want to make a thermal insulation layer? Generally speaking, the high-temperature aging room of electronic products installed on the first floor does not have a thermal insulation layer, and it can be done on the second floor and above.
Therefore, some customers may ask why they do not have a thermal insulation floor? Because they are mainly worried about the temperature resistance of the floor
.

Through years of practice, according to the statistics of construction and use over the past decades, the products of high-temperature aging rooms generally do not need the bottom plate as a thermal insulation layer.
The specific reasons are summarized as follows: 1.
To make the bottom plate thermal insulation Insulation will increase the cost
.

The aging room generally has aging cars entering it, so the bottom plate needs to have a strong bearing capacity, and the strength of the current thermal insulation warehouse board is not enough for the aging cars and operators to walk on it frequently
.

Therefore, 5 walls are used for thermal insulation, and the bottom plate is not
.

2.
The industry has basically not done bottom insulation for users
.

3.
Due to the high temperature resistance level of our buildings, the "Code for Fire Protection of Architectural Design" GB50016-2006 requires A ji, so there is no problem with the building's fire resistance and temperature resistance (high and low temperature)
.

If the customer requires the high-temperature aging room of electronic products to be the bottom insulation layer, and is willing to increase the cost, it is also possible
.