-
Preventive measures to avoid wear and corrosion of sand and gravel separator equipment
Time of Update: 2022-08-20
The surface of the sand and gravel separated by the equipment is relatively clean without a lot of sludge, and the ash content in the sand is relatively small, and because of the good separation effect, its water content is relatively small, and among them The water can be recycled and used, which can better make the sewage reach a single effect; and the wear resistance of the equipment itself is also very good and easy to operate .
-
2019 (3rd) Military and Civilian Dual-use Wear-Resistant, Anti-corrosion, Anti-Oxidation New Materials Forum
Time of Update: 2022-08-17
. Leaders, experts, scholars, engineering and technical personnel, and colleagues of relevant enterprises and institutions are sincerely invited to attend the meeting (people from overseas and foreign companies are not allowed to participate) to exchange views on the technology, design and application of high-end wear-resistant, anti-corrosion, and anti-oxidation new materials .
-
First-principles calculation and its application in anti-corrosion and wear-resistant coatings
Time of Update: 2022-03-03
Ti3C2Tx MXene nanosheets as two-dimensional fillers can improve epoxy resin crosslinking density, mechanical properties and barrier ability to corrosive media (Carbon 2020, 157, 217-233; Journal of Materials Science and Technology 2020, 54, 144-159; Tribology International 2021, 163, 107196; Chemical Engineering Journal, 2021, 410, 128310) .
-
High temperature corrosion-resistant ceramic coating under the flame wear-resistant anti-corrosion layer
Time of Update: 2021-01-16
China Coatings Online News Information: The occurrence of high temperature corrosion of metal under combustion, metal coating surface non-metallicization, its thermal efficiency began to decline, due
-
Boiler water cold wall anti-wear anti-corrosion coating increases the corrosion resistance and wear strength of pipe wall
Time of Update: 2021-01-16
Water-cooled wall pipe anti-corrosion coating on strong corrosion and rust anti-corrosion effect is good, flue gas corrosion media, different corrosion media content of fuel is also different, high temperature and wear resistance, it has become a water-cooled wall pipe corrosion serious, the material oxidation corrosion loss is large.
-
Anti-corrosion and wear-resistant high-temperature ceramic infrared coating energy-saving magic weapon
Time of Update: 2021-01-14
Industrial kilns, furnaces, boilers, blast furnaces, usually burning operating temperature of more than 1000 degrees C, high-temperature infrared ceramic energy-saving coating is a high radiation rate of heat-resistant materials, with this material applied to the inner wall of the furnace, can increase the radiation rate of the inner wall of the furnace, its role is to strengthen the heat exchange process in the furnace.
-
Chinese Academy of Sciences: Silicone modified graphene enhances epoxy anti-corrosion wear coating research progress
Time of Update: 2020-12-04
Bisphenol A epoxy resin is the largest yield and widest use of epoxy resin, a thermosolytic resin, with low curing shrinkage, easy molding, strong bonding ability, high mechanical strength and excelle
-
Ceramic high temperature anti-corrosion coating solves the problem of corrosion and wear of chimneys.
Time of Update: 2020-08-30
With or without heat exchangers (GGH), SO2, SO3, NOX, and other corrosive gases are prone to react with water vapor to produce dilute acid solutions (e.g. sulphate, sulphuric acid, nitric acid, etc.)
-
Coating general knowledge: high temperature far infrared coating has long service life of fire resistance, corrosion resistance and wear resistance
Time of Update: 2020-04-03
Core tip: combustion is a way of energy conversion It is a kind of energy transfer that transfers the potential energy in the fuel, emits heat through combustion, and transmits it to the heating mater