Why does the electroplating filter leak?

Why does the electroplating filter leak Why does the electroplating filter leak? Electroplating filters can leak for many reasons
.

If we want to find out why, we need to check the filter and find a solution
.

Below, we summarize four common causes of electroplating filter leakage
.

1.
The inlet pipe of the filter pump is blocked, check whether the inlet pipe and ball valve are blocked, and the fault needs to be removed in time
.

2.
The shaft seal of the filter pump is burnt or in an idling state
.

The first use of the pump requires adding water to the pump body to prevent idling of the pump
.

If the shaft seal is burnt, it needs to be replaced in time
.

3.
The impeller in the pump is stuck by foreign matter, causing the pipe of the electroplating filter to be blocked
.

In this case, the pump will usually vibrate or be noisy
.

After opening the main body, check the impeller for debris and clean it in time
.

4.
The separation of the pump impeller and the shaft sleeve causes the impeller to be out of sync with the motor shaft
.

It is recommended to replace the impeller and impeller key, and check whether the shaft seal is damaged
.