-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
- Cosmetic Ingredient
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
Why does the electroplating filter leak! Why does the electroplating filter leak? There are many
reasons for plating filter leaks.
If we want to find out the cause, we need to check the filter and then find a solution
.
Below, four common causes
of plating filter leakage are summarized.
1.
The inlet pipeline of the filter pump is blocked, check whether the inlet pipeline and ball valve are blocked, and find that the fault needs to be removed
in time.
2.
The shaft seal of the filter pump is burned out or in an idle state
.
The first use of the pump requires adding water to the pump body to prevent the pump from running idling
.
If the shaft seal burns out, it needs to be replaced
in time.
3.
The impeller inside the pump is stuck by foreign matter, resulting in blockage
of the electroplating filter pipeline.
In this case, the pump usually has vibration or noise
.
After opening the main body, check the impeller for debris and clean
it in time.
4.
The separation of the pump impeller and the shaft sleeve causes the impeller to be out of sync
with the motor shaft.
It is recommended to replace the impeller and impeller key and check whether the shaft seal is damaged
.